Mopar Remote Start System User Manual download pdf (Page 5)

Option Programming - continued.

C. Press and release the brake pedal. The horn will chirp and the lights will flash 1

time indicating the system is at option 1. Additional press and releases of the

brake pedal will advance to the next option. The horn will chirp and the lights

will flash according to which option is selected (i.e. Two chirps and flashes

indicates option 2).

D. Pressing the transmitter button changes the setting of the option. The status

LED (located in the main harness approximately 4” from the module) indicates the

setting of the option. LED “on” indicates the option is on, LED “off” indicates

the option is off.

E. Pressing and releasing the programming button again will put the system into

Option Bank 2. The horn will chirp and the lights will flash 5 times indicating

the system has entered Option Bank 2.

F. Press and release the brake pedal to cycle through the options in Bank 2.

Notes:

1. Once the system has reached the last option in a bank, pressing and releasing the

brake pedal will return back to Option 1 in that bank.

2. Once the system has reached Option Bank 2, pressing and releasing the program-

ming button will return back to Option Bank 1.

3. To reset options back to their default setting, while in option learn mode, push

and hold the transmitter button until the horn chirps and lights flash 5 times.

Tach Rate Programming (Required for system to operate).

A. Close hood.

B. Turn the ignition to the “on” position.

C. Press and hold the programming button. After 10 seconds the horn will chirp

and the lights will flash 3 times.

D. Release the programming button.

E. Press and release the programming button again. The horn will chirp and the

lights will flash 4 times indicating the system has entered Option Bank 1.

F. Press and release the programming button again. The horn will chirp and the

lights will flash 5 times indicating the system has entered Option Bank 2.

G. Advance to Option 2 by pressing and releasing the brake pedal 2 times. The horn

will chirp and the lights will flash 2 times indicating the system is at Option 2.

H. Start the vehicle with the key. The horn will chirp and the lights will flash once

approximately every 3 seconds indicating a valid tach signal.

I. Once the engine has settled to a normal idle speed, press and release the brake

pedal to set the tach rate.

J.Turn the ignition off.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Mopar Remote Start System User Manual Page 5